¼” screws at four jamb corners – screws bending corners screws bending. – tearing in frame wall at connections pushing limits of ASTM F □ Minimal. Mullion/Frame Design – Allowable Stress Design. ▫ Design Load = Equivalent 3 second design load ASTM F ▫ Info Required –. ▫ 1) Level of Protection. ASTM F (ASTM a) provides a framework for. designing blast- resistant glazing using either single LG or insula-. ted glass fabricated with LG.
|Published (Last):||21 October 2014|
|PDF File Size:||14.67 Mb|
|ePub File Size:||7.37 Mb|
|Price:||Free* [*Free Regsitration Required]|
This page was last edited on 28 Marchat The main keywords to present this standard are air blast pressure, blast resistant glazing, explosion, insulating glass, and laminated glass.
The standard explain different methods to check the thickness and type of blast resistant glazing fabricated with laminated glass to glaze a fenestration The main keywords to present this standard are astm f 2248 blast pressure, blast resistant glazing, explosion, insulating glass, and laminated glass.
Values given in parentheses are for information only.
Work Item s – proposed revisions of this standard. Use of the annealed or heat strengthened glass 22248 will also reduce the amount of astm f 2248 transferred into the structure.
ASTM F – Wikipedia
Referenced Documents purchase separately The documents listed below are referenced within astm f 2248 subject standard but are not provided as part of the standard. The fasteners that attach the framing system astm f 2248 supports the glazing to the structural framing system shall be designed to resist a uniform load acting on the blast resistant glazing that has ashm magnitude of at least: Historical Version s – view previous versions of standard.
The fasteners that attach the framing system that supports the glazing to the structural framing system shall be designed to resist a uniform load astj on the blast resistant glazing that has a magnitude of at least:.
Laminated glass fabricated with fully tempered glass plies astm f 2248 a tendency to leave the supporting glazing system frame after fracture whereas laminated glass fabricated with annealed or heat strengthened glass plies will remain in the frame and absorb 2428 load through tensile membrane behavior.
It is the responsibility adtm the user of this standard to establish appropriate safety and health astm f 2248 and determine the applicability of regulatory limitations prior to use. Link to Active This link will always route to the current Active version of the standard.
ASTM F 2248
Glass plies used to construct laminated glass are recommended to be either annealed or heat strengthened glass. The width of silicone or glazing tape is referred to as bite and is shown and discussed in Guide C This standard was published by ASTM F14 which is a committee specializes about on astm f 2248 products and services.
ASTM International which was funded inis an international standards developing organization that develops and publishes standards for a wide range of materials, products, systems, and services. Retrieved from ” https: The width of glazing tape shall be at least equal to two times but astm f 2248 more than four times the thickness designation of the glass to which it adheres.
ASTM F | Revolvy
Blast testing has shown that use of fully tempered glass astm f 2248, when asfm during a blast event, have poorer post blast performance than annealled or heat strengthened glass plies. The system shall be designed to ensure that the glazing fails prior to the ashm system that supports the glazing and its attachment to the structural astm f 2248 system. ASTM F is a standard practice for specifying an equivalent 3-Second Duration design loading for blast resistant glazing fabricated with laminated glass.